Markings for Soviet T34-85 1944/1945 1:16 Scale RC Tank Set 1
SKU:
£6.99
£6.99
This set of decals is suitable for a 1:16 scale tank or vehicle of similar size
The decals are designed to represent the markings for a Soviet T34-85 1944/1945 version
They are particularly effective under a winter whitewash effect
You will receive the sheet of waterslide decals (approximately 3.5cm by 23cm), along with a placement sheet to give some guidance
The decals are designed to represent the markings for a Soviet T34-85 1944/1945 version
They are particularly effective under a winter whitewash effect
You will receive the sheet of waterslide decals (approximately 3.5cm by 23cm), along with a placement sheet to give some guidance
You may also like..
Taigen Photo Etch Engine Grille for T34 Heng Long 1:16 Scale RC Tank
£5.69
All of our Taigen parts are genuine as we
are the UK approved supplier for Taigen
This item is from Taigen
It is made from brass and
allows you to replace the existing plastic moulded grill
A great way to start adding
more detail to your T34
MK Modellbau Aerial for Russian 1:16 Scale RC Tank
£8.05
Out of stock
This aerial is from MK Modellbau
It is the springy aerial type so will not snap and will spring back into the upright position when knocked or when the turret is turned
Ideal for any Russian vehicle in 1:16 scale or similar scratch build
It is the springy aerial type so will not snap and will spring back into the upright position when knocked or when the turret is turned
Ideal for any Russian vehicle in 1:16 scale or similar scratch build
Trumpeter 1:16 Scale WWII Soviet Officer Figure 00704
£14.99
£12.00
Only a few left!
This kit is from Trumpeter
It is a plastic kit (on sprues) to enable you to build a WWII Soviet Officer figure suitable for 1:16 scale vehicles and dioramas
Also included in the kit is a small photo etch part and a plastic plinth for the figure if required
The rear of the box shows suggested paint colours and the relevant codes for them. The instructions are quite limited, so some modelling skill will be required to assemble this model
It is a plastic kit (on sprues) to enable you to build a WWII Soviet Officer figure suitable for 1:16 scale vehicles and dioramas
Also included in the kit is a small photo etch part and a plastic plinth for the figure if required
The rear of the box shows suggested paint colours and the relevant codes for them. The instructions are quite limited, so some modelling skill will be required to assemble this model